EpicOutfit

Strap Pad is the ONLY stomp pad with a unique adjustable strap to ease your ride up and off the chairlift!

What are your advantages of using the Strap Pad over an ordinary stomp pad?

It makes your ride up the chair more comfortable by distributing the weight to both feet!
It reduces the stress on your ankles and knees.
Gives you more control when getting off the chairlift.
It reduces the wear and tear on your boots and laces from board edges.
The Strap Pad can be used as a handle to carry your ride.
The Strap Pad is see through so you don't loose the graphics on your board.

It's easy to install and use. Simply clean the surface where you'll install Strap Pad, remove the protective covering for the adhesive backing, stick to your board, adjust the Velcro strap and use.

APPLICATION INSTRUCTIONS ***VERY IMPORTANT***:
1) Thoroughly clean board surface with a 50/50 isopropyl (rubbing alcohol) and water mixture and dry
board surface completely.
2) In a room temperature environment, peel off the adhesive backing.
3) Use a heat gun or hair dryer to heat the bottom surface of the Strap Pad® for about 30 seconds or
until the pad begins to feel soft.
4) Place Strap Pad® on your snowboard deck between the bindings, closer to the rear binding.
5) Press down firmly with entire body weight on all areas of the Strap Pad® until adhesive appears clear.
6) Strap Pad® will reach maximum adhesion after 72 hours. Minimum 24 hours recommended.
TO INITIALLY ADJUST THE STRAP:
1) Strap Pad® is a one-size-fits-all product, adjustable to fit any size boot.
2) Completely disengage the Velcro® on both ends and lay flat, through both loops on the Strap Pad®.
After the Velcro® is disengaged and the strap is stretched flat, free end “1” should have Velcro® on both
sides and should be to your right. Free end “2” should be to your left and should have Velcro® on side
facing up and Strap Pad® logo on the other side facing down.
3) Slide your rear boot between the pad and the strap as indicated in the first illustration below.
4) Adjust end “1” first. If sizing for a youth boot (ages 10 and under), pull and fold end “1” all the way
over the boot so it lines up with the left end of the Velcro on the top of the strap. For larger size boots,
fold end “1” over so it is at the mid-point above the boot. Press Velcro® down tightly.
5) Pull end “2”, leaving just enough room to easily slide your boot in and out. Fold end “2” over the boot
and press Velcro® tightly. The Strap Pad